E46 series BMW 3

since 1998 of release

Repair and car operation



E46 series BMW 3
+ BMW 3 Cars (Е46)
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ engine Electric equipment
+ RKPP and transmission line
- Automatic transmission
   Removal and AT installation
   Adjustment of draft of the selector
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes



2d97642e


Adjustment of draft of the selector

Lifting and car installation on supports are dangerous! Therefore previously familiarize with Poddomkrachivaniye's Section and towage


 PERFORMANCE ORDER

1 Lift and establish the car horizontally on supports. Remove the bottom cover of an impellent compartment, address to the Section Removal and installation of the bottom cover of an impellent compartment.
2 Establish the selector in the situation "R".

3 Weaken a nut-2-on the lever of a box-3-, holding thus the tightening plug-1-a wrench from a provorachivaniye.

4 Wring out the lever of a box-3-forward in the provision of a parking. Thus pull a cable-4-in an opposite direction and again release it.
5 Tighten a nut-2 - the moment of 10 N • m, holding thus the tightening plug-1-for a shestigrannik.
6 Check operation of the selector. For this purpose include ignition. At the motionless car the selector can move from the situation "R" or "N" if the brake pedal is at the same time pressed.
7 Engine can be started only in position of the R and N selector.
8 Ignition key can be taken out only in position of the selector "R".
9 Otherwise it is necessary to address on HUNDRED.