E46 series BMW 3

since 1998 of release

Repair and car operation



E46 series BMW 3
+ BMW 3 Cars (Е46)
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
- Engine electric equipment
   General information and security measures
   + System of electronic control by ignition and injection of the petrol engine
   + ignition System
   - System of preheat of the diesel engine
      Check, removal and installation of candles of an incandescence
   + charge and start Systems
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes



2d97642e


System of preheat of the diesel engine

Check, removal and installation of candles of an incandescence

Check conditions:

- Tension of the storage battery equally not less than 11.5 Century.
- The safety lock of candles of the incandescence, located in the block of safety locks behind a ware box on the right, is serviceable. The arrangement of the block of safety locks is specified Specifications to Head Onboard electric equipment.

 REMOVAL AND CHECK

1 Remove the inlet pipeline, address to the Section Removal and installation of the inlet pipeline.
2 Glow plugs are between soaking-up channels in a head of cylinders. Rasstykuyte I will corrode incandescence candles. For this purpose it is necessary to compress clamps on tips.
3 Attach a diode control lamp to a positive pole of the storage battery (+) and put consistently to each glow plug.

The diode lights up: The glow plug is serviceable.
The diode does not light up: The glow plug is faulty, it is necessary to replace it.
4 Turn out glow plugs.

The key on 12 mm depth of 20 mm, for example, HAZET-4760-1 is for this purpose necessary.


 INSTALLATION

5 Screw glow plugs and tighten them the moment of 20 N • m.

Do not exceed the specified moment of an inhaling, the ring gap between a core of an incandescence and a carving part otherwise increases. It leads to premature failure of a candle.

6 Attach electric wires and fix them.
7 Establish the inlet pipeline, address to the Section Removal and installation of the inlet pipeline.