E46 series BMW 3

since 1998 of release

Repair and car operation



E46 series BMW 3
+ BMW 3 Cars (Е46)
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
- Power supply systems, injection and release
   Security measures and rules of observance of purity at work with fuel system
   Removal and installation of the sensor of a stock of fuel / fuel pump
   Check of the sensor of a stock of fuel
   + Power supply system of petrol engines
   + System of injection of fuel of the petrol engine
   + Power supply system of diesel engines
   - System of production of the fulfilled gases
      Operation of the catalytic converter
      Security measures for an exception of damages of the catalytic converter
      Turbokompressor
      Removal and installation of system of release
      Check of tightness of system of production of the fulfilled gases
      Removal and installation of the sensor of oxygen
      Removal and installation of a final collector
+ engine Electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes



2d97642e


Removal and installation of the sensor of oxygen

At the BMW car of the 3rd series sensors of oxygen are located before and after the catalytic converter to provide control of purity of the fulfilled gases.

Connecting cables of sensors of oxygen are not under repair and are not soldered. In the presence of damages the cable is replaced in a set.


 REMOVAL

Operation of lifting and car installation on supports is connected with danger! Therefore before carrying out operation familiarize with Poddomkrachivaniye's Section and towage

1 Lift and establish the car on supports.
2 Models 316i, 318i: Rasstykuyte I will corrode - 3-sensors of oxygen and turn out the sensor-4-of a reception pipe.

3 Models 320i, 323i, 328i: Rasstykuyte shtekerny connections of sensors of oxygen (two arrows on the right on an illustration).

Mark tips not to mix them at assembly. Uncover the engine to open tips, address to the Section Removal and installation of the bottom cover of an impellent compartment.

4 Disconnect the holder of a cable (the left arrow). Turn out oxygen sensors from a reception pipe. The cap key, for example, HAZET 468/4 is for this purpose necessary.


 INSTALLATION

Do not clear the oxygen sensor around top and do not allow contact to greasing. When drawing sheeting on the bottom sensors close.

5 Cover a carving of the sensor of oxygen with special high-temperature Nevar seez Compound greasing.

If the sensor of oxygen is rolled without high-temperature greasing, the carving burns over time and the sensor cannot be turned out. New sensors have the corresponding covering.

6 Screw the oxygen sensor in a reception pipe and tighten the moment of 55 N • m.
7 Lay an electric wire so that it did not fray and did not concern release system.
8 Establish an engine cover.