E46 series BMW 3

since 1998 of release

Repair and car operation



E46 series BMW 3
+ BMW 3 Cars (Е46)
- Current leaving and service
   Introduction
   Current leaving
   General information on control
   Check of levels of liquids
   Check of a condition of tires and pressure in them. Designation of tires and disks of wheels
   Replacement of impellent oil and oil filter
   Replacement of a filtering element of the air filter
   Checks of brake system
   Replacement of an element of the filter of air of salon
   Check of a condition of driving ridge belts
   Check of a condition and replacement of hoses of an impellent compartment
   Check of functioning of system of cooling and frost resistance of cooling liquid
   Check of a condition of system of production of the fulfilled gases
   Check of level of oil in a manual box of gear shifting
   Check of a condition of components of a suspension bracket and steering
   Check of a condition of protective covers of power shafts
   Check of level of liquid of system of hydrostrengthening of a wheel
   Visual check of a body and its bottom
   Check of seat belts
   Rotation and replacement of wheels
   Condition check, replacement of brushes and adjustment of a corner of screen wipers
   Check of a condition of the battery, care of it and charging
   Replacement of brake liquid
   Check and replacement of spark plugs
   Check of fuel system, replacement of the fuel filter. Operation of diesel model in the conditions of winter
   Greasing of loops and locks of doors
   Replacement of a battery of a key of remote control
+ Engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ engine Electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes



2d97642e


Check of fuel system, replacement of the fuel filter. Operation of diesel model in the conditions of winter

Petrol engine

Gasoline is extremely inflammable therefore at work with any components of fuel system it is necessary to accept special precautionary measures. Do not smoke, and do not come nearer to a venue of works with open fire or unprotected by the lamp shade carrying. Do not perform such works in the garages equipped with heating devices, working at natural gas (such, as водогреи, dryers, etc.). The working platform should be ventilated well. At gasoline hit on skin immediately wash away it water with soap. At carrying out any works with fuel system put on goggles and hold near at hand the fire extinguisher. In case of a gasoline spillage immediately wipe a pool, but do not keep the rags impregnated with gasoline in places where it can самовоспламениться.


1 If you felt a gasoline smell during movement or after the car stood on the sun, it is necessary to check a condition of all fuel system immediately.
2 Uncover a fuel tank and check it on existence of damages and corrosion. The sealing insert on a cover should be whole. In case of existence of damages or corrosion replace a cover.
3 Survey inlet and returnable lines of fuel system on existence of cracks. Make sure that connections between lines of fuel system and system of injection of fuel, and also between lines of fuel system and the built-in fuel filter did not weaken.

On the cars equipped with system of injection of fuel before serving fuel hoses, it is necessary to dump pressure in system.


4 As some components of fuel system - for example, the fuel tank and some lines of fuel system - are in the lower part of the car, they are easier for examining, when the car is raised by the winch. If it is impossible, поддомкратьте the car and establish it on support.
5 On the raised car examine a fuel tank and a bulk mouth on existence of holes, cracks and other damages. Special attention give to a connection condition between a bulk mouth and a tank. Sometimes leakages of fuel occur owing to weakening of collars of fastening of a rubber mouth or because of damage of a material of a mouth. Examine all arms and tapes of fastening of a fuel tank to make sure that it is reliably strengthened on the car.

Never, under no circumstances, try to repair a fuel tank (excepting replacement of its rubber components). A flame of the welding device or any other opened fire easily can lead to explosion of evaporations of gasoline in a tank.


6 Carefully check all fuel hoses and the metal lines going from a tank on existence of weakened connections, twisting, signs of wear of materials of hoses and other damages. If necessary make repair or replace the damaged sections.

Diesel engine

Operation in winter conditions


7 In diesel fuel no additives are added. Kerosene addition is allowed – address to Specifications.
8 If the engine is not got owing to a fuel zagustevaniye, to start it very hard. For start:

a) Remove the fuel filter and heat up in a water bath while fuel does not become liquid., or replace it new.
b) Roll the car in heated garage.
c) Spray fuel system hot water.
d) The BOSCH firm delivers a diesel heater for additional installation. The electric heater is established in the additional pipeline to the fuel filter.

At all it is not necessary to warm up system of injection or a fuel tank a blowtorch or other similar adaptation in view of danger of explosion!


Removal sediment/replacement of the fuel filter

Regularly or at emergence of the corresponding signal on the control panel from the filter water should be removed. Water is formed, as a rule, in a fuel tank as a result of condensation or gets together with fuel at filling station.

It will be necessary for carrying out work for you:

- The manual vacuum pump with capacity for collecting fuel from the filter, for example, KLANN LI-75200.
- Boss of the fuel filter.
- Sealing ring of a cover of the filter.
- Capacity for collecting the water being in the filter.

At hit of following diesel fuel on rubber details it is necessary to wipe the last at once (hoses of cooling liquid). Otherwise fuel gradually leads to failure of rubber details.

Protect environment, at all do not pour out the fulfilled oil and do not delete it together with a household waste.


 REMOVAL

- Near a workplace do not smoke, do not use open fire and heated or very hot subjects. There is a danger of emergence of a fire! Keep in readiness the fire extinguisher.

- Watch surely sufficient ventilation of a workplace. Fuel pairs are poisonous.

1 Switch off ignition.

2 Unscrew a cover on the case of the fuel filter a head on 27 mm.

3 Keep in readiness a rag. Take out an old fuel cartridge, wipe flowing-down fuel.


 INSTALLATION

1 Before installation of the new boss it is necessary to remove water from the case of the fuel filter. The ordinary manual vacuum pump, for example, KLANN LI-75200 is for this purpose necessary. Insert soaking-up tube into the filter case.

Do not allow liquid hit in the vacuum pump.

2 Manual pump pump out liquid from the filter case in capacity.
3 Check, whether there is no dirt in the filter case. If necessary wipe the case a rag.
4 Insert a new cartridge.
5 Screw a cover with a new sealing ring the moment of 25 N • m.
6 Include for one minute ignition so, without starting the engine. Toplivopodkachivayushchy the pump will join, will fill the fuel filter and will remove air from fuel system.
7 Visually check tightness of fuel system, in particular, in places of connections of the fuel filter.