E46 series BMW 3

since 1998 of release

Repair and car operation



E46 series BMW 3
+ BMW 3 Cars (Е46)
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ engine Electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   + Dignostika of electric elements
   - Lighting and alarm system
      Removal and installation/check of a sound signal
      Initialization of remote control
      Replacement of filament lamps of external lighting
      Replacement of filament lamps of internal lighting
      Removal and headlight installation
      Removal and installation of a ring cover of a headlight
      Removal and installation of the electric motor of adjustment of range of light
      Adjustment of headlights
      Gas-discharge lamps of a passing beam (xenon lamps)
      Removal and installation of a back lamp
   + Devices and equipment
+ electric equipment Schemes



2d97642e


Removal and headlight installation

 REMOVAL

1 Remove, if is available, the nozzle of a faroomyvatel located under a headlight, address to the Section Removal, installation and check of nozzles of a faroomyvatel.
2 Open a cowl.

3 Release an internal peak-1-and squeeze out it down from holders-2-.

4 Remove forward a peak on outer side-3-. For this purpose it is necessary to pull with force for a peak.
5 Rasstykuytes all shtekerny connections from a reverse side of a headlight.

6 Mark the provision of a headlight for what lead round a felt-tip pen of a washer of screws of fastening (an arrow on an illustration). Thanks to it at installation it will be possible to put a headlight in former situation. Unscrew screws of fastening of a headlight and remove it forward.


 INSTALLATION

7 Insert a headlight and tighten fastening screws by hand.
8 Expose a headlight so that washers of screws of fastening occupied the situation marked at removal.
9 If the new headlight is established, pull it completely forward. Close a cowl and expose a headlight so that it coincided with a body contour. Open a cowl and tighten screws of fastening of a headlight.
10 Join the socket of lamps.
11 Establish a peak outside under a headlight, incline inside and fix.
12 Fix a nozzle of a faroomyvatel if it is available, address to the Section Removal, installation and check of nozzles of a faroomyvatel.

In summary adjust a headlight on HUNDRED.