E46 series BMW 3

since 1998 of release

Repair and car operation



E46 series BMW 3
+ BMW 3 Cars (Е46)
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ engine Electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   + Dignostika of electric elements
   - Lighting and alarm system
      Removal and installation/check of a sound signal
      Initialization of remote control
      Replacement of filament lamps of external lighting
      Replacement of filament lamps of internal lighting
      Removal and headlight installation
      Removal and installation of a ring cover of a headlight
      Removal and installation of the electric motor of adjustment of range of light
      Adjustment of headlights
      Gas-discharge lamps of a passing beam (xenon lamps)
      Removal and installation of a back lamp
   + Devices and equipment
+ electric equipment Schemes



2d97642e


Removal and installation of a back lamp

 REMOVAL

1 Removal of the holder of a lamp of the corresponding back lamp is given in the Section Replacement of filament lamps of external lighting.

2 On an illustration the back lamp in a trunk lid, fixed by means of a collar is shown. Unscrew a fastening nut from within the car and remove outside a back lamp. At external back lamps it is necessary to unscrew some nuts of fastening on a lamp contour.


 INSTALLATION

3 in the presence of damages replace laying of a back lamp.
4 Insert a lamp and expose it in relation to adjacent elements of a body. Slightly tighten nuts the moment of 5 N • m.
5 Establish the holder of a lamp of a back lamp, address to the Section Replacement of filament lamps of external lighting.
6 Close a trunk lid or a door of a back and check tightness of a back lamp, whether for what water on a lamp and then check it got into car salon.
7 If water got, replace consolidation or a lamp.