E46 series BMW 3

since 1998 of release

Repair and car operation



E46 series BMW 3
+ BMW 3 Cars (Е46)
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ engine Electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   General information and security measures
   + Leaving and repair of damages of a body
   + External elements of a body
   - Internal elements of a body
      Removal and installation of forward peaks of the dashboard
      Removal and facing installation forward parts of the region of feet
      Removal and installation of the left ware box
      Removal and installation of the right ware box
      Removal and installation of the central console
      Removal and installation of the central armrest
      Removal and installation of a pocket of the console of switches
      Removal and installation of the console of switches
      Removal and installation of the electric motor of a drive of the movable panel of a roof
      Removal and installation of a mirror of an interior
      Interior mirror with automatic blackout
      Removal and installation of lateral facing of a luggage carrier
      Removal and installation of facing of the back panel
      Removal and installation of facing of a trunk lid
      Removal and installation of a head restraint of a forward seat
      Natyazhitel of a seat belt. Main data and security measures
      Removal and installation of a forward seat
      Removal and installation of a back seat
      Removal and installation of nozzles of a stekloomyvatel
      Adjustment of nozzles of a stekloomyvatel
      Removal, installation and check of nozzles of a faroomyvatel
      Removal and installation of levers of a screen wiper
      Removal and installation of the tank/pump of a washer
+ Onboard electric equipment
+ electric equipment Schemes



2d97642e


Removal, installation and check of nozzles of a faroomyvatel

 REMOVAL

1 Take out a nozzle-1-by means of a plastic wedge-2-of an obtyurator of a headlight and extend it against the stop.

At removal of a nozzle water therefore cover a nozzle with a rag follows and substitute the corresponding capacity. If necessary insert into a tube the corresponding stopper.

2 Remove breakthrough a nozzle from a tube. The tube after that itself departs back.


 INSTALLATION

The left and right nozzles differ from each other. Not to mix them, they have on the lower part marking of "R" and “L”. If the nozzle is replaced, disconnect an obtyurator and rearrange it on a new nozzle.

3 Insert a nozzle into an opening in an obtyurator of a headlight and enter into a tube.
4 Take out a nozzle check, whether the tube on accession is fixed. If necessary put on it and fix.
5 Insert a nozzle into a headlight obtyurator.


 CHECK

6 Include ignition, turn on the light and ask the assistant to turn on the switch of a stekloomyvatel.
7 Stream of water should get to the center of a headlight of near and far light.

If the faroomyvatel has to join again, previously it is necessary to switch on and off ignition as differently the washer is blocked on 3 mines

8 if necessary adjust nozzles.