E46 series BMW 3

since 1998 of release

Repair and car operation



E46 series BMW 3
+ BMW 3 Cars (Е46)
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ engine Electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   General information and security measures
   + Leaving and repair of damages of a body
   - External elements of a body
      Removal and installation of a front bumper
      Removal and installation/check of shock-absorbers of a bumper
      Removal and installation of a rear bumper
      Removal and installation of the back shock-absorber
      Removal and installation of a cover of a fairing
      Removal and installation of a forward wing
      Removal and cowl installation
      Cowl adjustment
      Removal and trunk lid installation
      Trunk lid adjustment
      Removal and installation of the lock/cylinder of the lock of a trunk lid
      Removal and installation of a gas-filled emphasis of a cowl/trunk lid
      Replacement of moldings and model emblem
      Removal, installation and door adjustment
      Removal and installation of facing of a door
      Removal and installation of the lock of a door
      Removal and installation of the cylinder of the lock
      Removal and installation of the external handle of a door
      Removal, installation and window adjustment
      Removal and installation of an electric window regulator
      Removal and installation of the electric motor of a window regulator
      Removal and installation of a mirror of an external look / sound signal of a high-pitch tone
      Removal and installation of glass of a mirror
      Removal and installation of the case of a mirror of an exterior
   + Internal elements of a body
+ Onboard electric equipment
+ electric equipment Schemes



2d97642e


Removal and installation of glass of a mirror

 REMOVAL

Before removal of glass of a mirror warm up the car to temperature +20°С. At lower temperature clips can easily break

1 Cast away mirror glass up.

2 For protection against damage paste over an edge of a mirror and an edge of the case of a mirror with a tape.
3 Take out glass from below by means of a wedge (the shooter on an illustration). Glass can be taken out also from below fingers.

4 Rasstykuytes I will corrode heating of a mirror and release, remove automatic equipment of a zatemneneniye of a mirror.
5 Remove mirror glass.


 INSTALLATION

6 Join the socket of heating of a mirror. Fix the tip of automatic equipment of a zatemneneniye.

7 Establish mirror glass so that brackets of fastening were over pads.

Installation of glass of a mirror carry out surely in mittens or apply a pure rag. There is a danger of a travmirovaniye owing to glass destruction!