E46 series BMW 3

since 1998 of release

Repair and car operation



E46 series BMW 3
+ BMW 3 Cars (Е46)
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ engine Electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   General information and security measures
   + Leaving and repair of damages of a body
   - External elements of a body
      Removal and installation of a front bumper
      Removal and installation/check of shock-absorbers of a bumper
      Removal and installation of a rear bumper
      Removal and installation of the back shock-absorber
      Removal and installation of a cover of a fairing
      Removal and installation of a forward wing
      Removal and cowl installation
      Cowl adjustment
      Removal and trunk lid installation
      Trunk lid adjustment
      Removal and installation of the lock/cylinder of the lock of a trunk lid
      Removal and installation of a gas-filled emphasis of a cowl/trunk lid
      Replacement of moldings and model emblem
      Removal, installation and door adjustment
      Removal and installation of facing of a door
      Removal and installation of the lock of a door
      Removal and installation of the cylinder of the lock
      Removal and installation of the external handle of a door
      Removal, installation and window adjustment
      Removal and installation of an electric window regulator
      Removal and installation of the electric motor of a window regulator
      Removal and installation of a mirror of an external look / sound signal of a high-pitch tone
      Removal and installation of glass of a mirror
      Removal and installation of the case of a mirror of an exterior
   + Internal elements of a body
+ Onboard electric equipment
+ electric equipment Schemes



2d97642e >


Removal and installation of a mirror of an external look / sound signal of a high-pitch tone

 REMOVAL

1 Lower glass completely down.
2 Remove door facing, uncover in the right part above, address to appropriate section.

It is not necessary to remove a lateral safety cushion.

3 Take out a small screw-driver two clips of-2-covers-1-from a forward end face of a door.

4 Uncover-1-, thus begin from below. Take out a cover at the door limiter.

5 Take out a cover above from a flat clip (poses. And on an illustration) also wring out so that to provide up access to screws of fastening of a mirror.

6 Rasstykuytes I will corrode protection against a jamming glass (it is white / a black cable).

7 Unscrew screws of fastening-2-sound signals of a high-pitch tone-1-and remove it.

8 Rasstykuytes I will corrode exterior mirrors.
9 Holding a mirror outside, turn out the screw-3-.
10 Remove a mirror, thus pass through a door electric wires.


 REMOVAL

11 Establish a mirror, thus pass through a door electric wires.
12 Holding a mirror outside, fix it the screw - 3-.
13 Fix a sound signal of a high-pitch tone. Tighten screws-2-and-3 - the moment of 6 N • m.
14 Join the socket of a mirror of an exterior and protection against a jamming glass.
15 Press protection against a jamming into a clip - And-.
16 Insert a cover of protection against a jamming on the limiter of a door and fix two clips at a door end face.
17 Establish door facing, address to appropriate section.