E46 series BMW 3

since 1998 of release

Repair and car operation



E46 series BMW 3
+ BMW 3 Cars (Е46)
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ engine Electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   General information and security measures
   + Leaving and repair of damages of a body
   - External elements of a body
      Removal and installation of a front bumper
      Removal and installation/check of shock-absorbers of a bumper
      Removal and installation of a rear bumper
      Removal and installation of the back shock-absorber
      Removal and installation of a cover of a fairing
      Removal and installation of a forward wing
      Removal and cowl installation
      Cowl adjustment
      Removal and trunk lid installation
      Trunk lid adjustment
      Removal and installation of the lock/cylinder of the lock of a trunk lid
      Removal and installation of a gas-filled emphasis of a cowl/trunk lid
      Replacement of moldings and model emblem
      Removal, installation and door adjustment
      Removal and installation of facing of a door
      Removal and installation of the lock of a door
      Removal and installation of the cylinder of the lock
      Removal and installation of the external handle of a door
      Removal, installation and window adjustment
      Removal and installation of an electric window regulator
      Removal and installation of the electric motor of a window regulator
      Removal and installation of a mirror of an external look / sound signal of a high-pitch tone
      Removal and installation of glass of a mirror
      Removal and installation of the case of a mirror of an exterior
   + Internal elements of a body
+ Onboard electric equipment
+ electric equipment Schemes



2d97642e


Removal and installation of the external handle of a door

 REMOVAL

1 Remove the lock cylinder, address to appropriate section.

2 Pull the handle of a door-1-outside and displace approximately on 2 mm back. Press the handle approximately on 4 mm inside and pull back.

Thus, the mechanism of the lock is fixed. If the door handle at removal lasts only back and is released, it is necessary to fix the lock mechanism manually, address to the subsection "Installation".


 INSTALLATION

3 Check directing-2-and a support-1-, if necessary replace the handle.

4 If the handle of a door is replaced, remove consolidation of the handle and replace it.


 VERIFICATION/ADJUSTMENT OF THE PROVISION OF THE MECHANISM OF THE LOCK

For installation of the external handle of a door the mechanism of the lock is necessary for fixing. It means that the lever-4-is in situation, as is shown in an illustration.

If the lever-4-, as is shown in an illustration costs inside, the external handle of a door cannot be established. In this case it is necessary to establish the mechanism of the lock in assembly situation, that is to fix.

 

5 Fix the lock mechanism: Enter a screw-driver-5-through an opening-6-and press the lever-4-outside, pull a little back and fix.

6 Insert the handle with directing to an opening.
7 Insert the handle with a reception part behind the lever-4-and press a door.
8 Displace the handle approximately on 4 mm forward, towards a loop, and fix.