E46 series BMW 3

since 1998 of release

Repair and car operation



E46 series BMW 3
+ BMW 3 Cars (Е46)
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ engine Electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   General information and security measures
   + Leaving and repair of damages of a body
   - External elements of a body
      Removal and installation of a front bumper
      Removal and installation/check of shock-absorbers of a bumper
      Removal and installation of a rear bumper
      Removal and installation of the back shock-absorber
      Removal and installation of a cover of a fairing
      Removal and installation of a forward wing
      Removal and cowl installation
      Cowl adjustment
      Removal and trunk lid installation
      Trunk lid adjustment
      Removal and installation of the lock/cylinder of the lock of a trunk lid
      Removal and installation of a gas-filled emphasis of a cowl/trunk lid
      Replacement of moldings and model emblem
      Removal, installation and door adjustment
      Removal and installation of facing of a door
      Removal and installation of the lock of a door
      Removal and installation of the cylinder of the lock
      Removal and installation of the external handle of a door
      Removal, installation and window adjustment
      Removal and installation of an electric window regulator
      Removal and installation of the electric motor of a window regulator
      Removal and installation of a mirror of an external look / sound signal of a high-pitch tone
      Removal and installation of glass of a mirror
      Removal and installation of the case of a mirror of an exterior
   + Internal elements of a body
+ Onboard electric equipment
+ electric equipment Schemes



2d97642e


Removal and installation of the cylinder of the lock

 REMOVAL

1 Uncover at a door end face.

The cover consists of two parts. At first take out the central part-1-a screw-driver, then disconnect and take out an external part-2-.

2 Turn out through an opening in a door leaf the screw-2-a face key on 5 mm. Thus the screw press inside that it did not fall.

3 Pull a cover - 3-with the lock-4-cylinder a little back and release it, then pull outside. The screw is protected from falling by the corresponding nut.

4 Carefully take out a fiksatorny hook-5-and uncover-3-the lock-4-cylinder.

The second clamp is on the opposite side and on an illustration is not shown.


 INSTALLATION

5 Check existence of damages on a fiksatorny hook of a cover of the cylinder of the lock, if necessary a cover replace.
6 Put on the lock cylinder a cover and fix it.
7 Unscrew a lock nut of the screw with an internal shestigrannik if it was fixed.
8 Insert the lock cylinder with a cover into a door opening. Thus the pin of the cylinder should enter into the lock. If necessary insert a key into the cylinder of the lock and turn a pin a little.
9 Press the cylinder to a door and a little to a loop of a door and fix.
10 Wrap the screw with an internal shestigrannik.

Do not tighten the screw too strongly, differently the cylinder of the lock can jam.

11 Insert a cover from a door end face. Press into an opening at first an external part, then central.