E46 series BMW 3

since 1998 of release

Repair and car operation



E46 series BMW 3
+ BMW 3 Cars (Е46)
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ engine Electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   - Steering with the hydraulic booster (servoupravleniye)
      Removal and installation of the block of a safety cushion on a steering wheel
      Removal and installation of a steering wheel
      Removal and installation of a tip of steering draft
      Removal and installation of steering draft
      Removal and installation of the pump of the hydraulic booster
      Filling with liquid and air removal from hydrosystem of the amplifier of a wheel
      Corners of installation of forward wheels. Check of installation of wheels
+ Body
+ Onboard electric equipment
+ electric equipment Schemes



2d97642e


Corners of installation of forward wheels. Check of installation of wheels

Corners of installation of wheels considerably influence stability of the car, wear of tires and fuel consumption. Distinguish the following corners of installation of wheels:

Disorder is an inclination of a wheel in the vertical plane relatively the average line of the car. It can be positive if wheels are inclined outside or negative if wheels are inclined inside. The disorder corner, generally influences uniformity of wear of tires of forward wheels. If disorder of one wheel positive, and another negative, withdraws the car aside at movement on a straight line.

Convergence – a difference of distances between lobbies and back edges of wheels. The positive convergence means that wheels are in front located more closely to each other, than behind at measurement at height of an average point of a wheel. The negative convergence means that wheels in front are at bigger distance from each other, than behind.

The cross-section inclination of an axis of turn of a wheel is a corner between an axis of an inclination of a rotary fist and the vertical which has been carried out through a point of fastening of a wheel, looking in the longitudinal direction of the car.

At the expense of corners of disorder and a cross-section inclination of an axis of turn of a point of a contact of wheels with the road settle down closer to an axis of a rotary fist. It supports so-called “a running in shoulder”, driving is easier than subjects. Also blows from roughness of a covering are less transferred to a steering.

Corner of a longitudinal inclination of an axis of turn. The axis concerning which there is a wheel turn, takes place in space so that its lower part is directed forward. Such corner of a longitudinal inclination is called as positive. At positive value of a corner self-return of a wheel to average situation after turn improves.

Convergence adjustment

1 Establish forward wheels directly. On the helmsman to a shaft and a case of the steering mechanism there is a marking. Establish a steering so that the specified markings coincided.

2 Weaken on each steering draft a tightening nut (the shooter on an illustration). Adjust a convergence rotation of the left and right steering drafts. Thus the left and right steering drafts turn for a shestigrannik for the identical size. Watch that at adjustment spherical hinges and covers were not braided.


3 After the completion of adjustment of a convergence tighten tightening bolts at steering drafts the moment of 80 N • m.