E46 series BMW 3

since 1998 of release

Repair and car operation



E46 series BMW 3
+ BMW 3 Cars (Е46)
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ engine Electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   - Steering with the hydraulic booster (servoupravleniye)
      Removal and installation of the block of a safety cushion on a steering wheel
      Removal and installation of a steering wheel
      Removal and installation of a tip of steering draft
      Removal and installation of steering draft
      Removal and installation of the pump of the hydraulic booster
      Filling with liquid and air removal from hydrosystem of the amplifier of a wheel
      Corners of installation of forward wheels. Check of installation of wheels
+ Body
+ Onboard electric equipment
+ electric equipment Schemes



2d97642e


Removal and installation of the pump of the hydraulic booster

Petrol engine

 REMOVAL

1 Suck away oil from the tank by means of the corresponding device or a usual shliyets.
2 Remove the bottom cover of an impellent compartment, address to the Section Removal and installation of the bottom cover of an impellent compartment.
3 Remove maple a belt, address to the Section Removal, installation and a tension of a maple belt.

Hit in hydrosystem of any pollution is not allowed. Open pipelines and hoses close jams or polyethylene, having fixed it a rubber plait.

4 Release a collar-1-and disconnect soaking-up hose.

5 Unscrew a cap nut and disconnect the pressure head line-2-.
6 Unscrew bolts of fastening-3-and disconnect a pulley keeping him from rotation for an internal shestigrannik-4-shaft of the pump a face key on 10 mm.

7 Unscrew from above two bolts of fastening-6-pumps of the hydraulic booster and remove the pump.-3-bolts of fastening of a pulley,-7-pulley.


 INSTALLATION

8 Insert into place the pump of the hydraulic booster and fix it bolts.
9 Establish into place a pulley and fix it.
10 Fix the pressure head line a cap nut.
The inhaling moments depending on diameter of a carving following:

М10 - 12 N • m
М14 - 35 N • m
М16 - 40 N • m
11 Put on maple a belt, address to the Section Removal, installation and a tension of a maple belt.
12 Establish the bottom cover of an impellent compartment, address to the Section Removal and installation of the bottom cover of an impellent compartment.
13 Fill system with new oil and remove from system air.

Repeatedly it is not necessary to apply the liquid which was in the use.