E46 series BMW 3

since 1998 of release

Repair and car operation



E46 series BMW 3
+ BMW 3 Cars (Е46)
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ engine Electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   - Steering with the hydraulic booster (servoupravleniye)
      Removal and installation of the block of a safety cushion on a steering wheel
      Removal and installation of a steering wheel
      Removal and installation of a tip of steering draft
      Removal and installation of steering draft
      Removal and installation of the pump of the hydraulic booster
      Filling with liquid and air removal from hydrosystem of the amplifier of a wheel
      Corners of installation of forward wheels. Check of installation of wheels
+ Body
+ Onboard electric equipment
+ electric equipment Schemes



2d97642e


Removal and installation of steering draft

 REMOVAL

1 Mark paint the provision of a forward wheel concerning a nave. It will allow to establish an otbalansirovanny wheel in the former situation. Weaken bolts of fastening of a wheel at the car standing on the earth. Lift a forward part of the car and remove a wheel
2 Remove the bottom cover of an impellent compartment, address to the Section Removal and installation of the bottom cover of an impellent compartment.
3 Remove by means of a stripper the hinge of steering draft from a rotary fist, address to the Section Removal and installation of a tip of steering draft.

4 Weaken fastening of a collar and shift back a cover.

5 Move a gear lath as it is possible more deeply to exclude possible damage of a lath and its support.

6 Unscrew steering draft from a gear lath (the shooter on an illustration).


 INSTALLATION

7 Measure a gear lath. If new steering draft is established, screw it so that to provide the size which has been removed at measurement of old draft.
8 Tighten a tightening nut of a tip of steering draft the moment of 80 N • m.
9 If it is necessary, clear of greasing a pin of the hinge of steering draft, and also a seat in a rotary fist.
10 Check a cover and if necessary replace it.
11 Fix steering draft not to a gear lath the moment of 100 N • m.
12 Put on a cover and fix it a collar. Watch that the cover was not braided.
13 Insert a tip into a rotary fist. Screw a new being self-stopped nut on a pin of the hinge of steering draft and tighten the moment of 65 N • m.
14 Establish into place a wheel so that the markings put at removal, coincided. Previously grease with a thin layer of bearing greasing a seat of a disk of a wheel on a nave. Bolts of fastening of a wheel do not grease. Rusty bolts replace with the new. Fix a wheel bolts. Lower the car on wheels and tighten bolts cross-wise the moment of 100 N • m.
15 Establish the bottom cover of an impellent compartment, address to the Section Removal and installation of the bottom cover of an impellent compartment.
16 Check a track on HUNDRED, if necessary adjust.