E46 series BMW 3

since 1998 of release

Repair and car operation



E46 series BMW 3
+ BMW 3 Cars (Е46)
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ engine Electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   + Forward suspension bracket
   - Back suspension bracket
      Removal and installation of the back shock-absorber
      Removal and installation of springs of a suspension bracket
   + the Steering with the hydraulic booster (servoupravleniye)
+ Body
+ Onboard electric equipment
+ electric equipment Schemes



2d97642e


Removal and installation of springs of a suspension bracket

 REMOVAL

1 Mark paint the provision of the corresponding back wheel concerning a nave. It will allow to establish at assembly an otbalansirovanny wheel in its former situation. Weaken bolts of fastening of a wheel at the car standing on the earth. Lift a back part of the car, put it on supports and remove a back wheel.
2 Remove a power shaft, address to appropriate section.
3 Remove facing of a fuel tank in a back part.
4 Disconnect the stabilizer of cross-section stability on the relevant party.

5 Disconnect the holder of a brake hose from the longitudinal lever.

It is impossible to subject a brake hose to stretching loading.

6 Prop up the bottom cross-section lever-4-the garage lift, thus enclose wooden laying.

If this condition is not observed, the suspension bracket after a detachment of the shock-absorber falls down.

7 Disconnect the shock-absorber-1-from the holder of a wheel. Note the provision of both washers for the subsequent correct installation. The persistent washer shows-3-rubber support towards a head of a bolt-2-.
8 Lower the garage lift.

9 Wring out a wheel suspension bracket down and take out a spring-1-aside.


 INSTALLATION

10 Check linings of springs above and below on existence of damages, if necessary replace. Thus the top lining of a spring before installation grease with means for sliding, for example, soap or paste for installation of tires.
11 Wring out a suspension bracket down and insert a spring.
12 raise the bottom lever the garage lift A little.
13 Fix the shock-absorber below, without tightening while a fastening nut. Do not forget to put thus a washer from both parties of fastening of the shock-absorber. The persistent washer of a rubber support should show towards a bolt head.
14 Take away the lift.
15 Fix the holder of a brake hose at the longitudinal lever.

Thus the brake hose should not be exposed to stretching loadings.

16 Fix the stabilizer on the relevant party of the car.
17 Establish a power shaft, address to appropriate section.
18 Establish into place a back wheel so that the markings put at removal coincided. Previously grease with a thin layer of bearing greasing aligning belt of a disk of a wheel on a nave. Bolts of fastening of a wheel do not grease. Rusty bolts replace. Wrap bolts. Lower the car on wheels and tighten bolts cross-wise the moment of 100 N • m.
19 In an empty condition of the car tighten a bolt of fastening of the shock-absorber the moment of 100 N • m, address to the Section Removal and installation of the back shock-absorber.
20 Fix facing of a fuel tank in a back part.