E46 series BMW 3

since 1998 of release

Repair and car operation



E46 series BMW 3
+ BMW 3 Cars (Е46)
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ engine Electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   - Forward suspension bracket
      Removal and installation of an amortization rack
      Dismantling amortization rack/removal and shock-absorber/spring installation
      Shock-absorber check
      Shock-absorber utilization
      Removal and installation of the bearing of a wheel
      Removal and installation of a beam of a forward suspension bracket
   + Back suspension bracket
   + the Steering with the hydraulic booster (servoupravleniye)
+ Body
+ Onboard electric equipment
+ electric equipment Schemes



2d97642e


Shock-absorber utilization

Places of drilling of openings in the shock-absorber case

And — an opening in diameter of 3 mm
In — an opening in diameter of 6 mm


Shock-absorber fastening in a vice when cutting the case of the shock-absorber

 


That the shock-absorber could be used again, it is necessary to merge from it oil.

At all it is not necessary to pour out oil of the shock-absorber together with a household waste since it can harm to environment. Local authorities should inform on places of reception of the fulfilled oil.

Pressure of gas in the shock-absorber makes to the 25th bar. Therefore when opening the shock-absorber fence off a workplace and surely put on goggles.


Be opened the shock-absorber can in two ways: by its zasverlivaniye and a cutting.

Shock-absorber drilling


1 Clamp the shock-absorber removed from the car vertically in a vice a rod down.
2 Drill an opening of Ø3 of mm in a point And an external cover of the shock-absorber.

At gas-filled shock-absorbers gas leaves after the first wall of a pipe is drilled. Observe safety distance. Continue to drill further to an internal pipe (about 25 mm).


3 Drill other opening of Ø6 of mm in a point In so that to receive an opening in an internal pipe.
4 Hold the shock-absorber over capacity and squeeze out oil rod moving in different directions on full size of a course.
5 Let's to oil flow out completely.
6 Utilize the shock-absorber as usual metal.

Shock-absorber cutting

1 Clamp an amortization rack in a vice.
2 Establish труборез, for example Stahwille Express 150/3, and cut an external pipe.

At the gas-filled shock-absorber there is a gas.


3 Lift a rod. Thus hold an internal pipe an alligator wrench and press down so that it at slow promotion of a rod remained in an external pipe.
4 Remove a rod from an internal pipe.
5 Put the shock-absorber over capacity and merge completely oil.
6 Utilize the fulfilled oil according to the established rules.